View HDM08-48D-S24_4492744.PDF datasheet online --- IC-ON-LINE

Datasheet File OCR Text:

H HiTRON
PCB-MOUNT DC-DC CONVERTER ENCAPSULATED MODULES 8 WATTS SINGLE & DUAL OUTPUT HDM08-S & HDM08-D SERIES
FEATURES:
LOW COST SINGLE & DUAL OUTPUT WIDE 4:1 & 2:1 INPUT RANGE 8W ISOLATED OUTPUT SIX-SIDED METAL SHIELD
SPECIFICATION
INPUT SPECIFICATION
Input Range: Wide 4:1 & 2:1 DC input range. See Ratings Chart. Input Voltage: Nominal 12/24/48 Vdc. Input Current: Various with input range and load. See Ratings Chart. Input Fuse: Use external fuse. Input Filter: Pi-Network. Undervoltage Shutdown: 8Vdc. Isolation Resistance: 1,000 Mega Ohms. Isolation Voltage: 1,500Vdc. EMI: Six-sided metal shielding.
OUTPUT SPECIFICATION
Output Voltage: See Ratings Chart. Output Current: See Ratings Chart. Voltage Accuracy: Main O/P 2.0% typical. Line Regulation: Various with output voltages. 0.5% typical. Load Regulation: Various with output voltages. Single O/P1.0% typical. Dual O/P 2.0% typical. Noise & Ripple: Typical 100mV for 3.3V/5.0V & 1.0% for others peak to peak. OVP: Built-in on main output. Overload Protection (OLP): Fully protected against output overload and short circuit. OLP set at about 125-150% rating output wattage. Consult the factory for OLP setting.
GENERAL SPECIFICATION
Efficiency: 84% typical various with input. Switching Frequency: Fixed frequency 100K Hz. Circuit Topology: 100K Hz. Forward Circuit. Transient Response: Peak deviation 200mV. Recovery time< 3mS for a 25% load change. Case: Black coated steel with non-conductive metal base. Power Density: 10Watts. / Cubic inch. Commercial Grade only. MTBF: 1,000,000 hours. Mil Std 217, 25C. Operating Temperature: -10 to +70C range. 0C to +60C full load without derating. From +60C, derating linearly to half load @+70C.
(Refer to Derating Chart.)
Temperature: -20C to +85C. Temperature Coefficient: 0.03% /C. Cooling: Convection cooling up to +60C @ full load. At least 100LFM moving air is recommended for F-L > +60C in a confined area. Humidity: Up to 95%RH, Non-condensing.
NOTE: (1) All measurements are at nominal input, full load, and +25C unless otherwise specified. (2) Line Regulation measured from High to Low Lines at full load. (3) Load Regulation measured from Full Load to 1/2 Full Load at nominal input. (4) Correct fuse size by calculating the max. DC current drains at low Line input & Load and then adding 20-25for the desired fuse size.
Due to requests in market and advances in technology, specifications subject to change without notice.
-17-
INPUT/OUTPUT & VOLTAGE/ CURRENT RATINGS CHART
SINGLE OUTPUT MODEL NO.
HDM08-24B-S03 HDM08-24B-S05 HDM08-24B-S09 HDM08-24B-S12 HDM08-24B-S15 HDM08-24B-S24 HDM08-24D-S03 HDM08-24D-S05 HDM08-24D-S09 HDM08-24D-S12 HDM08-24D-S15 HDM08-24D-S24 HDM08-48D-S03 HDM08-48D-S05 HDM08-48D-S09 HDM08-48D-S12 HDM08-48D-S15 HDM08-48D-S24 INPUT Vdc 18.018.018.018.018.018.09.09.09.09.09.09.020.020.020.020.020.020.036.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 72.0 72.0 72.0 72.0 72.0 72.0 INPUT CURRENT OUTPUT N. L. (mA) F.L. VO1(Vdc) 46 290 3.3V 46 393 5.0V 46 420 9.0V 46 415 12.0V 46 425 15.0V 46 430 24.0V 50 290 3.3V 50 393 5.0V 50 420 9.0V 50 415 12.0V 50 425 15.0V 50 430 24.0V 46 145 3.3V 46 196 5.0V 46 210 9.0V 46 207 12.0V 46 212 15.0V 46 215 24.0V OUTPUT VO1(A) 1.50A 1.50A 0.90A 0.67A 0.55A 0.35A 1.50A 1.50A 0.90A 0.67A 0.55A 0.35A 1.50A 1.50A 0.90A 0.67A 0.55A 0.35A CASE SIZE DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C
DUAL OUTPUT MODEL NO.
HDM08-24B-D03 HDM08-24B-D05 HDM08-24B-D12 HDM08-24B-D15 HDM08-24D-D03 HDM08-24D-D05 HDM08-24D-D12 HDM08-24D-D15 HDM08-48D-D03 HDM08-48D-D05 HDM08-48D-D12 HDM08-48D-D15
Symbols: "" OVP built-in.
INPUT Vdc
18.018.018.018.09.09.09.09.020.020.020.020.036.0 36.0 36.0 36.0 36.0 36.0 36.0 36.0 72.0 72.0 72.0 72.0
INPUT CURRENT N. L. (mA) F.L.
46 46 46 46 50 50 50 50 46 46 46 46 300 420 420 420 300 420 420 420 150 210 210 210
OUTPUT (Vdc) +VO1 -VO2
+3.3V + 5.0V +12.0V +15.0V +3.3V + 5.0V +12.0V +15.0V +3.3V + 5.0V +12.0V +15.0V -3.3V -5.0V -12.0V -15.0V -3.3V -5.0V -12.0V -15.0V -3.3V -5.0V -12.0V -15.0V
OUTPUT (A) +VO1 -VO2
0.80A 0.80A 0.34A 0.27A 0.80A 0.80A 0.34A 0.27A 0.80A 0.80A 0.34A 0.27A 0.80A 0.80A 0.34A 0.27A 0.80A 0.80A 0.34A 0.27A 0.80A 0.80A 0.34A 0.27A
CASE SIZE
DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C DM2C
"" Double Feedback.
MECHANICAL DIMENSIONS: MM [INCHES]
WEIGHT: 27.5g (0.95 Oz.) PIN ASSIGNMENT
PIN NO. PIN# 1. PIN# 2. PIN# 3. PIN# 4. PIN# 5. SINGLE -INPUT +INPUT DC-COM NO PIN +VO1 DUAL -INPUT +INPUT -VO2 DC-COM +VO1
DERATING CHART
CASE SIZE: DM2C
-18-

▲Up To Search▲

Price & Availability of HDM08-48D-S24

	To Download HDM08-48D-S24 Datasheet File
If you can't view the Datasheet, Please click here to try to view without PDF Reader .